QAL1 approved particulate CEM which meets US EPA PS-1 requirements for Opacity monitoring from combustion stacks
QAL1 approved particulate CEM which meets US EPA PS-1 requirements for Opacity monitoring from combustion stacks
Robust multi corner cube reflector provides truer reflection of transmitted light compared to traditional “mirror type” reflectors providing greater confidence in measurement
• Outstanding reliability with no continuously moving parts
• Automatic in-situ zero and span checking with built-in calibration audit and zero drift correction
• Dual light source, with patented Flood LED source provides robust check of the detectors
and minimises effects of temperature instability
| Measurement capability | 0 – 100% (opacity); 0-1000 mg/m3 (concentration) |
| Sensor Variants | cast aluminium, epoxy coated |
| Stack Temperature Ranges | up to 600°C |
| Functionality and QA Checks | Automatic zero and span; automatic correction for zero drift |
| Interface | • Available as standalone sensor pair (no controller) or with either standard control unit (Interface module) for single stack or with ProController for multi-sensor networks • Available with standard control unit (Interface module) for single stack or with ProController for multi-sensor networks |
| On-board data logging (control unit only) | User configurable Long term, Short term or Pulse logging |
| Output | RS232, RS485 (Modbus), Ethernet Digital Alarm and 4/20mA (number of outputs dependant on system configuration (with or without controller) |
| Air Purge | blower required |
| Enclosure Protection Rating | IP65 |
| Measured parameters | Dust |
| Technology | Opacity |
| Measurement/Monitoring capability | 0-100%* |
| Stack/Duct diameter suitability | up to 10m |
| Flue gas temperature | up to 600°C |
| Baghouse | YES |
| Cartridge Filter | ✓ |
| Ceramic Filter | ✓ |
| Coalescent Filter | ✓ |
| Cyclone | ✓ |
| Electrostatic Precipitator (ESP) | YES |
| Wet Electrostatic Precipitator | ✓ |
| Wet Scrubber | ✓ |
| Sensor variants | Cast aluminium, epoxy coated |
| QA checks | YES |
| *Application dependant | |
• Stacks after bag filters, cartridge filters, cyclones, electrostatic precipitators, no filtration
• Non-condensing / dry flue gases
Typical Applications:
• Incineration
• Metals (eg Steel/Aluminium)
• Minerals (eg Cement/Gypsum)
• Chemicals (eg Refinery / Rubber)
• Power Generation Plant (eg Coal/Biomass)
Approved flue gas velocity CEM for stack velocity, volumetric flow and pollutant mass release calculations when linked to Gas and Dust CEMS
The PCME STACK 990 is an approved particulate measurement system for continuously monitoring emissions from industrial.
Compressor Cooler for CEMS (wash out optimized) with 1-4 Gas Path, Flow Rate up to 150 I/h and update optionsto full conditioing system
The INFRALYT 80 is a customer specific configurable gas analyzer for applications at industry and laboratory. It measures up to 8 gases at once, special
